Home >> Product >>  High Pressure Grinding Mill

High Pressure Grinding Mill Introduction

High Pressure Grinding Mill is used in grinding the non-inflammable and non-explosivestuff which has the Moh's hardness below 9.3,humidity less than 6%,such as mining,metallurgy,chemical industry,construction,etc.The final products change from80 to 425 meshes and part of them can add up to 1000fineness.By being equipment particular parts,the machines can produce thick powders ranging from 30 to 80 meshes.

High Pressure Grinding Mill Technical Advantage:

(1)The final product size ranges from the maximum particle diameter of 0.613mm (30mesh) to the finest diameter of 0.033mm (425 mesh). A few materials can reach 0.013mm (1000 mesh).
(2)Compared with the common grinding mill under the same power conditions, the capacity can be increased by 10%; moreover, under the performance of high-pressure springs, the rollers grinding pressure on raw materials can be raised by 800-1200kg
(3)The grinding device adopts a superposition multi-grade sealing with good sealing performance.
(4)All the mineral materials with Mohs hardness below 9.3 can be crushed

High Pressure Grinding Mill Working Priciple:

The whole system of High pressure Grinding Mill consists of main frame, decelerator, classifier, piping device, blower, jaw crusher, dustpan elevator, electromagnetic vibration feeder, and electric switch box , motor, etc.
(1) Materials are firstly crushed by the jaw crusher; then the crushed materials is transferred to a hopper by the elevator and fed uniformly, quantitatively and continuously by the vibration feeder in the grinding chamber of the main frame for grinding. The grinding particles are brought up by the air current of the blower into the classifier for classification. The particles with the required fineness are brought up by the air current through the pipe into a cyclone collector for separation and collection and the finished particles are discharged from a pipe outlet.
(2) Due to some moisture contained in the materials to be grinded, the heat resulting from grinding leads to the vaporized air which changes the airflow volume. Moreover, the outside air inhaled from the narrow gaps, of the piping connections can increase the volume of air current. Therefore, it is necessary to adjust to redundant air pipe between the blower and the main unit for keeping the balance of the air current. The redundant air is then guided into a cloth bag of a dust cleaner to collect the fine powder in the air. And the redundant air is discharged after purification.
(3) the main unit runs with a central shaft is driven by a transmission device. The top of the shaft is connected with a quincunx stand, on which a grinding roller is installed to form a swing support, the grinding roller not only rotates around its own axis due to the friction, it also rotates around the ring.

High Pressure Grinding Mill Technical Data:

Note: If there is any modification,all parameter and overall dimension are subject to the operating instructions.